eyelash perm


Order

Perm Instructions

Lash & Brow Tint

Tinting Instructions

Home

Prices

 

 

 

 

 






 

Eyelash Perm Instructions

 

Preparations: 
Remove all makeup from eyelashes and lid with oil-free remover.  Clean area with warm water, for best results, allow 10 minutes for eye area to completely dry before beginning the perming procedure.  Remove contact lenses, if any.  Immerse six to eight cotton pads in water and squeeze out the excess water.  
Procedure:  
1.Use the following guidelines to determine the rod size.  

a.       Smaller rod is best for the short eyelashes or if a tighter curl is desired.

b.       Medium is the most commonly used for a good all around curl.

c.        Large rod is best for the longer lash or looser curl (men prefer this size).  

 
2. Place a ½ round damp cosmetic pad on the lower lid before beginning the perm to prevent 
fumes from entering the client’s eyes.
3. Remove rod from packaging. Note: The rod is pre-treated with glue.  Bend the rod slightly in 
a “C” curve to fit the shape of the eyelid.  May be cut to fit smaller eyes.  
4. Place the glue that comes with the kit at the base of the lashes; use enough glue to cover an 
area equal to the length and twice the width of the roller.  Do not place on lid without first coating 
the lid with perm glue because the roller is pretreated with glue and will be difficult to remove from
lid without additional.   It is ok if there is excess glue; the permanent lotion will work through it.  
If the rod does not adhere on the ends, place a small amount of glue on the ends and use a wood 
applicator (included with the kit) to hold the rod in place.  
5.After positioning the roller, add more glue on top of the roller.  Using the wood applicator, carefully 
place the lashes on the rod.  Make sure the lashes are “straight” and do not overlap.  

6. Use an orangewood stick or a clean applicator stick to gently dab a small amount of the permanent 
wave lotion (step 1) on the lashes.  Use a cotton pad to wipe off the excess permanent wave lotion and 
place it over the lashes.  Make sure there is enough lotion on the pad to touch the lashes; this will aid 
in creating heat for perming.  If you have a facial steamer, you may use it at this time.  
7. Let the lotion remain on the eyelashes for seven to fifteen minutes (depending on the texture of the 
lashes).  Clean the eyelid skin immediately after applying the lotion to avoid irritation.  Do not overuse 
the perm lotion.  Excess permanent wave lotion will be wasted and will not create a better curl.  To 
determine if the perm process is complete, carefully lift one or two lashes away from the rod with a 
wood applicator and check curl.  If necessary leave permanent wave lotion on until desired curl is attained.  
8. Remover cotton pad.  Use a newly moistened cotton pad to remove all traces of permanent wave lotion.  
9. Follow the same steps used for applying the permanent wave lotion to apply the setting lotion (step 2).  
Use a new cotton pad every time.  Wipe the excess lotion on the pad and place it over the lashes.  Let it 
set for seven to twelve minutes based on the length of time the permanent lotion was left on.  
10. Remove the cotton pad follow the same steps used for applying the permanent wave lotion to apply 
the nourishing agent (step 3).  Let nourishing set for five minutes.  
11. Use cleanser (step 4) with another clean cotton pad.  Gently clean the upper part of the roller touching 
the eyelid.  Using water damp Q-tip slowly roll downward, freeing the lashes from the rod.  Clean lashes 
with a warm damp cotton pad.  Apply hypoallergenic  moisturizer to the eyelid (optional) to sooth and 
re-moisturize the skin.  

Caution:

  • Practice of this procedure is highly recommended before servicing clients.
  • Technicians should wear gloves throughout  the procedure.
  • This product is for use by licensed , trained, solon professionals only.  
Eyelash Perm Ingredients:  
    1.  Perm Lotion (step 1) Ammonium Thioglycolate Solution, Ammonia Water 25%, Monoethanolamine, 
Tomin-A, Perfume, and Distilled Water.
    2. Setting Lotion (step 2): Sodium Bromate, Tomin-A, Perfume, and Distilled water.  
    3. Nourishing Agent (step3):Aloe Extract, Sod PCA, and Distilled Water.
    4. Cleanser (step 4): Celquat, Surfactant, and Distilled Water.  
    5. Eyelash Perm Glue: Synthetic Resin Emulsion, Butyl Hydroxy Anisol, and Distilled Water.

 
WARNING:  IF ANY OF THE PERM KIT SOLUTION OR GLUE GETS INTO THE EYES, IMMEDIATELY 
FLUSH WITH WATER.  KEEP OUT OF REACH OF CHILDREN, IF ACCIDENTALLY INGESTED CONTACT A PHYSICIAN IMMEDIATELY AND INDICATE THE INGREDIENTS OF THIS PRODUCT.